Sink Stopper Won T Seal

The photo on the right fig.

Sink stopper won t seal.

But sink stoppers fail. Peek above the sink to make sure the stopper is fully closed and that the pop up rod is pushed all the way down 3. A pivot rod that connects to the back of the drain pipe a perforated strap a clevis and a screw that locks the strap onto the stopper rod. Re tighten the thumb screw by turning clockwise.

Now that the bottom of the tailpipe if free from the p trap loosen the nut that connects it to the threaded bottom of the sink drain. Water may leak or refuse to drain around a sink pop up for a number of reasons. Remove stopper from drain. Gasket to push outward.

The gasket located under the stopper may also need to be adjusted. The culprit is often a buildup of hair around the base of the stopper or the pivot rod mechanism. It moves the stopper in the opposite direction to the lift rod. This is a repair you can do yourself.

To reach the stopper the ball rod needs to be removed first. Unthread the sink stopper s tailpipe from the underside of the drain. Most sink stopper tailpipes are made of pvc and will be connected to the drain with a pvc compression nut that you can loosen by hand. Fix a sink stopper.

To remove unthread the rod nut pull the ball rod out and remove the stopper from the drain. The ball rod holds the stopper in the drain. A sink stopper with a push pull rod control at the faucet is a great modern convenience. If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.

Find replacement parts on amazon. If water still does not hold in the sink the next check will be the actual stopper seal. A sink stopper mechanism isn t difficult to understand. 6 shows the gasket seated correctly between the clicker assembly and the stopper.

Remove clip from ball rod. When they do they are often unsightly and an irritation. How to fix a sink pop up drain stopper. The clicker may have been over tightened causing the.

The lever hooks onto the stopper through a hole or hook on the bottom of a long plastic flange that s attached to the stopper. If a sink won t hold water look up behind the sink with a flashlight if needed to identify the following parts. The ball rod is inserted into the side of the drain and attached with a nut. Simply remove the plunger clean and if necessary replace.

5 shows the gasket pushed out of position. When you push or pull on the lift rod it activates a lever the extends through the drain tailpiece.